With 14 figures throughout the front yard, power distribution becomes a
major issue. At first I used the common three way adapters sticking them
inside plastic bags to keep moisture away. However, It became obvious
something less dangerous was needed./
Thus three power boxes like the one pictured at right
were built in about 1996. They are made from cedar siding that was salvaged when a family friend
demolished his old garage to build a larger version.
The edges where the two halves join are
covered with a gasket type material to try and form a weatertight seal.
Notches at each end allow for passage of cords.
The hasp allows for use of a padlock if necessary but so far this has not been necessary.
Once the winter snow falls, it is hard to tell where the power boxes are.
|